GY30 Concrete Reinforcement Tester

The GY30 concrete reinforcement detector is mainly used for the position, distribution, and direction of reinforcement in concrete structures, as well as the thickness of the protective layer

Function Features

After sales excellent boundary grid and profile scanning mode, can automatically measure the spacing between steel bars, and display the distribution map of steel bars in real time;

The four-wheel scanning system provides more accurate measurements, and the configuration of extension rods makes on-site operations more convenient and faster

The path sensor is connected to the host using a single wire, making it easy to use on site

The speed is suitable for scanning function, and the scanning speed does not affect the testing accuracy

Integrity merchant data calibration function, which can calibrate and test data based on different diameters of steel bars

Adopting a reset type power on/off, automatically shutting down after 6 hours of no operation

Real time display of protective layer thickness and steel reinforcement signal image, with automatic locking for smaller values

Automatic storage of detection data, providing real-time statistical analysis results on site, facilitating guidance for construction operations

Data analysis software makes your post-processing work easy to complete

According to the standard

GB 50010-2010 "Code for Design of Concrete Structures" (2015 edition)

GB 50204-2015 "Code for Acceptance of Construction Quality of Concrete Structures"

GB/T 50344-2019 "Technical Standard for Inspection of Building Structures"

JGJ/T 152-2019 "Technical Specification for Inspection of Steel Reinforcement in Concrete"

DB11/T 365-2016 "Technical Specification for Thickness and Diameter of Steel Reinforcement Cover"

GB/T 50784-2013 "Technical Standard for On site Inspection of Concrete Structures"

JJF 1224-2009 "Measurement of Thickness of Steel Reinforcement Cover and Floor slabs"

Instrument Calibration Specification "

JTG/T J21-2011" Specification for Testing and Evaluation of Bearing Capacity of Highway Bridges "

Technical Indicators

Reinforcement diameter setting range: Φ 6mm~Φ 50mm

Large range: 5-110mm

Allowable error for large protective layer thickness: ± 1 (mm) 5-69mm; ±2(mm)70~89mm； ± 4 (mm) 90-110mm

Diameter estimation applicable range:--

The diameter estimation has a large error:--

Profile mode/Grid mode: √

Scanning range: Excellent after-sales service

Storage quantity: 2 million measuring points

Data correction function (spacing/thickness):--

Data transmission interface: U, etc.

Power supply method: dry battery